Owner's manual

6-16 Beginning Programming
Figure 6-7 Teaching a Pot
3. Click the checkbox next to Weight Control to activate that feature and enter 20 for
the weight.
4. Use the position controls to move the camera crosshairs to the center of the upper left circle
in the Pot diagram on the tutorial board.
5. Click
Teach.
 The next line in your program should appear similar to the one below.
POT: 1, 20.000, (2.171, 3.418)
To program area fill:
1. Click on
Dispensing Elements from the Program Commands toolbar.
2. Select
Area Fill from the Dispensing Elements Toolbar.
 The Teach Window will open.
3. Type
0.1 in the Spacing text box. See Figure 6-8.
 This is the spacing between each line. See Figure 6-9.