Owner's manual

5-42 Programming Basics and Setup
12. Click on OK.
 The dispensing head moves to the location you defined earlier as the workpiece origin.
 NOTE If your dispensing system DOES NOT include a Height Sensor, then continue
with the next step. If your dispensing system DOES include a Height Sensor,
go to Step 17.
13. If your dispensing system does not include a height sensor, you are asked to teach the
substrate height.
14. Use the position controls to move the dispensing head to a location on the board that
represents the dispensing height.
 Do not teach the height of a chip or part. FmXP is requesting the height of the substrate,
not the height of a chip or part.
15. Activate the Z-Axis Controls and slowly lower the dispensing head until the needle tip
touches the substrate surface.
 Be careful not to crash the needle tip onto the substrate.
16. Click on
Teach.
17. Click on
Done.
 The Teach Window closes.
Saving a Program
1. Click on
File in the menu bar and select Save As.
2. In the File Name text box, type
Program1.
3. Activate the
Attach Fluid File(s) feature by clicking on it.
 FmXP will attach the currently active fluid file. Make sure
FMW.FLU is attached.
4. Click on
OK.
 The file will automatically be saved in the Program folder under the FmXP root
directory as
Program1.fmw.
5. You have just created a new workpiece and are ready to begin programming.