Owner's manual

5-40 Programming Basics and Setup
Loading a Board
1. For systems equipped with a conveyor, set the Tutorial Board (Side 1) at the mouth of
the conveyor.
 Use the conveyor position controls in FmXP to set the proper width.
 Click on the
Load Board icon to load the board into the dispensing area. The clamps
should push the board up to the bottom of the rail slot.
2. For gantry dispensing systems, place the Tutorial Board (Side 1) onto the heat plate or
dispensing area plate and fasten with the tooling pins.
Creating a New Program File
1. In the Programming Window, click on
File and select New or click on Program Wizard
to create a new program.
 The Create Workpiece dialog box opens. See Figure 5-24.
Figure 5-24 Create Workpiece
2. Choose Two fiducials.
3. Click on
OK.
 A Teach Window opens asking you to teach the first point-defining axis. This will
define the Workpiece Alignment.