Owner's manual

5-34 Programming Basics and Setup
28. Click on the Image tab.
Figure 5-20 Model Finder Fiducial Window – Image Tab
 Gain controls the way digital values are assigned to the analog signal from the camera.
 Lower Gain values will increase the contrast of the image and may help to differentiate
the fiducial from the background. However, a low Gain value may also amplify “noise”
in the image.
 It is recommended that you first adjust the light level, and then adjust the Gain only if
necessary. The default value of the Gain is 255.
29. Click on the
Model Finder tab.
30. When you are satisfied with the fiducial, click on
Teach.
31. Test the fiducial by clicking on
Find Fid.
 The Test Results indicate if the fiducial was found or not, its found XY coordinates,
how sure the system is that it has found the correct fiducial, and how long it took to
locate the fiducial.
32. Click on
Next to accept the results.
33. You are now asked to select the method for Fid 2.
34. Select
Model Finder.
35. Click on
Next.