Owner's manual

Programming Basics and Setup 5-15
To setup Flow Rate Parameters:
 NOTE The Flow Rate Parameters tab is only available on systems equipped with DP-Series or
DV-Series Dispensing Valves.
1. Click on the
Flow Rate Parameters tab. See Figure 5-8.
2. Click on
Enable Flow Rate Maintenance to activate Flow Rate Maintenance and select the
desired options. Flow Rate Maintenance options are described in Table 5-2.
 NOTE If Variable Valve Speed is enabled, the tab will display a "Valve Speeds" column and
and buttons. Refer to Section 7 - Advanced Programming for
instructions on enabling Variable Valve Speed. Variable Valve Speed is available on
Axiom X-1000 Series and Millennium M-2000 Series platforms with DP-Series or
DV-Series Dispensing Valves.
Variable Valve Speeds Enabled
Figure 5-8 Fluid Manager - Flow Rate Parameters