Owner's manual

Programming Basics and Setup 5-11
5.4 Programming Setup
Programming Setup is a recommended routine to be performed prior to beginning a programming session.
Programming setup consists of defining fluid files, setting workpiece alignment options, and teaching
workpiece fiducials.
 NOTE Before you begin a programming session, it is recommended that you perform a
Prompted Setup or Scripted Prompted Setup routine. Refer to Section 4 - System
Configuration and Setup for step-by-step instructions on performing a Prompted Setup or
Scripted Prompted Setup routine.
This subsection includes the following topics:
• Fluid Setup
• Workpiece Alignment
• Teaching Fiducials
You will also perform a sample programming setup exercise that includes:
•
Creating a fluid file

Teaching workpiece alignment
•
Attaching a fluid file
 Teaching workpiece fiducials
•
Loading a board

Saving a program
•
Creating a new program file
In the exercise detailed in this section, the following acronyms are used:
• (ULHC) Upper Left-Hand Corner
• (URHC) Upper Right-Hand Corner
• (LLHC) Lower Left Hand Corner
• (LRHC) Lower Right Hand Corner