Owner's manual

System Configuration and Setup 4-121
To perform a Camera-Assisted Scripted Valve Offsets Procedure:
1. Clear the work area of any obstacles that might interfere with dispensing head movement.
2. In the Main Window, click on
Configuration > Machine Offsets > Machine Offsets
Parameters
and verify the following in the Machine Offsets Parameters window and click
on
OK:

Scripted Valve Offsets and Camera Assisted Script are selected.

Setup Fiducials is performed if you wish to use fiducials to locate dispensing
area devices. Refer to 4.5.3.2 Setup for details.
 All other options are correct. Refer to 4.3.9 Setup Scripts Options for details.
 If a message appears asking you to restart FmXP, click on
OK.
3. In the Main Window, select
Configuration > Machine Offsets > Scripted Valve Offsets.
 The Machine Setup window (Figure 4-101) opens.
4. In the Machine Setup window, verify the
Valve 1 radio button is selected and click on
Run to End.
 If a message warns you that the dispensing head will move to the Home position, click
on
Yes.
 The first of a series of Teach Windows opens.
5. Follow the on-screen prompts. Click on
Help if you have questions.
 The Teach Window content and appearance may vary depending on your system
configuration and options selected.
 When a setup task has been completed, a check mark appears next to the task.
 Any tasks not applicable to your system configuration will be skipped.
6. If your dispensing system has a Dual-Action Dispensing Head, repeat Steps 4 and 5 except
click on the
Valve 2 radio button.
 You will start the routine with Task #2 since you have already established a safe
Z height.
7. When setup tasks are complete, click
Exit in the Machine Setup window.
8. When the message appears notifying you that the offsets routine is complete, click on
OK.
NOTE If you end the routine prematurely, you will receive an error message similar to the one in
Figure 4-99. Click on
OK to exit the routine and save the tasks completed or click on
Cancel to continue.