Owner's manual

4-118 System Configuration and Setup
4. Click on Run next to Task 1.
 A Teach Window opens.
5. Follow the on-screen prompts. Click on
Help if you have questions.
 The Teach Window content and appearance may vary depending on your system
configuration.
 When the task has been completed, a check mark appears next to the task.
6. Repeat Steps 4 and 5 for the other tasks listed in the window (as desired).
NOTE Any tasks not applicable to your system configuration will be skipped.
7. If your dispensing system has a Dual-Action Dispensing Head, click on the
Valve 2 radio
button and repeat Steps 4 through 6.
 You will start with Task #2 since you have already established the safe Z height.
8. When setup tasks are complete, click
End in the Setup Valve Offsets window.
NOTE If you end the routine prematurely,
you will receive an error message
similar to the one in Figure 4-99.
Click on
OK to exit the routine and
save the tasks completed or click on
Cancel to continue.
Figure 4-99 Offsets Error Message
Figure 4-100 Setup Valve Offsets Window