Owner's manual

4-90 System Configuration and Setup
Figure 4-77 Conveyor Configuration Window (ACL Plus)
Table 4-14 Conveyor Configuration Options –ACL Plus
Feature Description
Teach Window
Mode
NOTE Mode controls the conveyor behavior in the Programming Window
only and is generally used for testing purposes during programming.
This command has no effect on run commands executed from the
Production Window.
Disabled
: Disables the upstream and downstream conveyor communication.
Workpieces can be manually loaded using FmXP, but the conveyor cannot be
used as an in-line system.
Continuous Run
: The conveyor operates as an in-line system.
Pass-through
: On an in-line system, the conveyor conveys parts only. A part waits
at the dispensing station until the downstream system is ready to accept it, but no
dispensing is performed.
Conveyor Files
Click on the drop-down arrow to display all available options:
 Startup File Name: Executes custom conveyor instructions at FmXP
startup.
 Pre-Board Run File Name: Executes custom conveyor instructions before
dispensing begins.
 At Reset File Name: Executes custom conveyor instructions after resetting
the conveyor.
 At Abort File Name: Executes custom conveyor instructions when a
program has been aborted.
Change
: Click to select the conveyor atom (.acl file) you wish to execute at the
chosen time.