Owner's manual

4-64 System Configuration and Setup
4.4.2.1.3 DV/SV Series Valves
Command Description
Forward Speed Valve forward speed.
Reverse Speed Valve reverse speed. Reverse is used for the suckback feature.
Acceleration Rate of speed increase for forward and reverse speed settings.
Allow Variable Valve
Speeds
Enables the Variable Valve Speed feature. See 7.9 Variable
Valve Speed.
Home/Refill Local Reservoir
Timeout
The timeout value used when refilling the local fluid reservoir. If
the reservoir fails to refill in this time, an error message is
displayed.
Local Reservoir Stopcock
Delay
The time (ms) to status the stopcock moving from the dispense
to the refill position. An error is reported if the stopcock does not
begin movement within this time period.
Home/OBFS Change-out
Timeout
The timeout value used when refilling the local fluid reservoir
after an onboard fluid sensor change-out.
Number of Priming Cycles
The number of priming cycles for the local fluid reservoir to
execute. Each cycle consists of a purge of the reservoir to its
low fluid sensor level, followed by a refill of the reservoir.
Toggle syringe pressure
with valve motor
Fluid air is applied when motor is on.
Constant syringe pressure
during dispensing
Fluid air is always on.
Figure 4-58 DV/SV Series Valve Settings – Settings Tab