Owner's manual

4-44 System Configuration and Setup
Table 4-6 Beacon Configuration Window (Continued)
Command Description
Program
States 1
(Continued)
Low Fluid - Critical:
The beacon/alarm comes ON when:
 "Use software tracking" is selected in Fluid Manager
and the syringe weight reaches the specified critical
syringe weight value.
 "Use 1-position sensor" is selected in Fluid Manager
and the hardware sensor is triggered.
 "Use 2-position sensor" is selected in Fluid Manager
and the critical low fluid sensor is triggered.
Low Fluid - Warning:
The beacon/alarm comes ON when:
 "Use software tracking" is selected in Fluid Manager
and the syringe weight reaches the specified
warning syringe weight value, and/or
 The “Use 2-position sensor" Low Fluid Check option
is selected in Fluid Manager and the low fluid
warning sensor (of the 2-position sensor) is
triggered.
The beacon/alarm is OFF when the fluid level reaches the
critical level.
Low Fluid – Board
Countdown:
The beacon/alarm comes ON when:
 Critical low fluid is detected, and
 The "Boards After Low Detect" setting is greater
than zero, and
 The number of boards specified in "Boards After
Low Detect" has not been processed.
The beacon/alarm is OFF when any of the above
conditions is false.
Program
States 2
Purge Cup Overflow:
The beacon/alarm comes ON when a purge is pending and
the cumulative purge time (minutes) exceeds the "Purge
Cup Overflow Limit" value in Purge Station Setup. The
light/alarm is OFF after the operator acknowledges being
informed of the possible overflow condition.
Conveyor Empty:
The beacon/alarm comes ON when there are no boards on
the conveyor for a specified time during a production run.
The beacon/alarm is OFF otherwise.
Pot Life Low:
The beacon/alarm comes ON when the "Notify below" time
period set in Fluid Manager has been reached. The
beacon/alarm is OFF otherwise.
Pot Life Expired:
The beacon/alarm comes ON when the pot life set in Fluid
Manager has been reached. The beacon/alarm is OFF
otherwise.
Fluidmove
States
Exit Fluidmove: You are exiting FmXP.
Initialize Fluidmove: FmXP will initialize.
Fluidmove Idle: The default state when no other beacon state is “true”.
Dispenser Homing
The beacon/alarm comes ON when the dispensing head is
moving to the Home position. The beacon/alarm is OFF
otherwise.