Manual

4-42 System Configuration and Setup
Workpiece Alignment
Workpiece alignment refers to the position of the board or part in relation to the Dispensing Head X- and
Y-axes. Even if the board is slightly askew, FmNT can use workpiece alignment to adjust the patterns
and dispense correctly. Once you have established workpiece alignment parameters, workpiece
alignment will be performed at the beginning of each production run and at the beginning of each new
board in the run. For instructions on how to set up workpiece alignment, refer to “Workpiece Alignment”
in the Programming Basics and Setup section.
Conveyor Setup
The Conveyor Setup process defines, tests, and reinitializes the Conveyor(s) on your dispensing system.
To set up the Conveyor:
1. Start FmNT.
!Refer to “Starting FmNT” in the Tour of Fluidmove section for assistance.
2. In the Main Window, click on
Configuration.
3. Click on
Setup Conveyors.
!The Setup Conveyor dialog box opens (Figure 4-22).
Command Description
Reinitialization
Re-establishes communication between system computer and the
Conveyor.
Configure Opens a Conveyor configuration menu.
Test I/O Tests the Conveyor input/output.
Personality
Parameters
Opens a window displaying the personality parameters for the
Conveyor. Not available on X-1000 Series Dispensing Systems.
Figure 4-22 Setup Conveyors