Manual

System Configuration and Setup 4-25
Table 4-5 E10 Equipment States - Configuration Options
Command Description
Enable E10
Equipment States
Allows this feature to be enabled or disabled. FmNT must be restarted
when changing this selection.
Powerup State…
Determines which state FmNT will boot up in if not powered down
correctly (power fails or system crashes) and the current state was
STANDBY or PRODUCTIVE. The downtime will always be logged as
UNSCHEDULED DOWNTIME and FmNT will reboot into either
UNSCHEDULED DOWNTIME or STANDBY, depending on the
selection made.
Select action…
Determines what the software should do if the operator is attempting to
run production, but a state other than PRODUCTIVE is locked. The
software will either warn the operator that it cannot transition to
PRODUCTIVE state and continue (without changing states) or
automatically unlock the state and transition to the PRODUCTIVE state
before continuing, depending on the selection made.
Powerdown Time
Interval
The “Powerdown Time Interval” is the time between E10 state
“heartbeats”. A heartbeat is a timestamp that is written to a file on disk
every specified number of seconds. This timestamp is used to
determine how long a system has been powered down after a power
failure or system crash. The resolution of the interval is 60 to 3600
seconds.