Manual

System Configuration and Setup 4-23
Command Description
Change/Lock State
This tab allows an operator to manually change or lock a state. If a
state is changed and not locked, it may transition to a new state when a
transition point is encountered. If the state is “locked”, a lock icon will
appear on the E10 status bar and the state will not change until it is
unlocked by the operator.
Statistics
The statistics tab shows the actual time spent and the percentage of
time spent in each of the six equipment states. Two categories for
each state are displayed. One shows the time spent in that state since
FmNT was started. The other value is the accumulated time since the
Reset button was last pressed. Pressing Reset resets all values.
Figure 4-12 E10 Equipment States