Manual

4-18 System Configuration and Setup
Default Post Run Park Location
The Default Post Run Park Location feature allows you to designate a location for the Dispensing Head to
wait between program runs. Moving the Dispensing Head to a designated location while it waits for the
next board or part to enter the dispensing zone can greatly increase throughput.
To set up the Default Post Run Park Location:
1. Select
Configuration from the Main Menu.
2. Choose
Setup Runtime Preferences.
3. Click on
Default Post Run Park Location from the cascading menu.
!The Post Run Park Location dialog box, shown in Figure 4-10 opens.
Command Description
Enable Move to
Park Location
A check mark in this box indicates that the feature is active.
Move to First Fid
Location
Moves the Dispensing Head to the location of the first program fiducial to
await the next board or part.
Move to System
Location
Allows you to designate a system location (Purge Station, Scale Station,
etc.) where the Dispensing Head will wait for the next workpiece.
Location
Works in conjunction with Move to System Location. Choose a location
by clicking on the arrow and selecting from the list.
Set Active Valve
Lets you establish separate Default Post Run Park Locations for each
valve, if your dispensing system is equipped with the Dual-Action
Dispensing Head.
Figure 4-10 Post Run Park Location