Manual

System Configuration and Setup 4-17
Command Description
Home Z Axis Homes the Z-axis at the start of a production run.
Home All Axes Homes all axes at the start of a production run.
Move To System
Location
Moves the Dispensing Head to a defined location at the start of a
production run. The available locations are defined in the Setup
Locations menu.
Check System Air
Pressure
Performs a system air pressure check upon startup. If system air
pressure is too low, a dialog box opens with a warning indicating that the
system air pressure is too low.
Pre-board Purge
Time
Establishes a purge duration, which will be performed before each board
during a production run. Make sure this setting does not interfere with
Move to First Fid Location before setting a purge time.
Enable Run Setup
For Production
Enables the Run Setup options in the Run Window.
Enable Lot Control
For Production
Enables the Lot Control feature. When this feature is active, the GO
button in the Run Window will be disabled unless a lot has been started.
Disable All Alarms Disables all audible alarms.
Enable Only User
Selected Alarms
Enables only those alarms that you have setup. There are three
configurable alarms: Vision Parameters Alarm, Low Fluid Alarm in Fluid
Manager Setup and the Heater Alarm.
Enable All Alarms
Including Error
Messages
All audible alarms are activated and all error messages will issue an
audible alarm as well.
Figure 4-9 Runtime Preferences