Manual

3-16 Tour of Fluidmove
Process Toolbar
The Process Toolbar is located along the top of the Programming Window and contains frequently used
FmNT commands. The commands associated with each icon on the Process Toolbar are identified in
Figure 3-11. As you move the cursor over a button, notice that a “tip” appears below the button,
explaining its function. When you move it away, the tip disappears.
If a button is grayed-out, the command is not available at this point in the programming session. The
Wet/Dry Run Mode and Video Display buttons toggle between the two modes. See Appendix A for a
detailed description of the Process Toolbar commands.
Figure 3-11 Process Toolbar
*The program will stop after completing the current board.
Cut Program Lines
Copy Program
Lines
Paste Program
Lines
Run a Program
Pause Run at End
of Next Command
Stop Run at End
of Pro
g
ram*
Run Program in
Ste
p
s
Abort Run
Display Video
Purge Valve
Measure Flow
Rate
Create a New
Program File
Open a New
Program File
Save Current
Program
Print Current
Program
Load a Board
Unload a Board
Wet or Dry Run
Mode
Move Dispensing Head
to Home Position
A
ccess Jog
Controls
Access
Hel
p
Return to
Main Menu