Manual

A-8 Appendix A - Programming Menu Detail
Run
Run
G
o
Dr
y Run
W
et Run
Pass T
hrough Run
S
top
P
ause
Si
ngle Step
A
bort
R
un From Cursor
Manual Board L
oad
Manual Board U
nload
D
ry Mode
Run To F
ile
D
emo Dispense Mode
Go
Dr
y Run
W
et Run
Pass T
hrough Run
S
top
P
ause
Si
ngle Step
A
bort
R
un From Cursor
Manual Board L
oad
Manual Board U
nload
D
ry Mode
Run To F
ile
D
emo Dispense Mode
Run
Run
G
o
Dr
y Run
W
et Run
Pass T
hrough Run
S
top
P
ause
Si
ngle Step
A
bort
R
un From Cursor
Manual Board L
oad
Manual Board U
nload
D
ry Mode
Run To F
ile
D
emo Dispense Mode
Go
Dr
y Run
W
et Run
Pass T
hrough Run
S
top
P
ause
Si
ngle Step
A
bort
R
un From Cursor
Manual Board L
oad
Manual Board U
nload
D
ry Mode
Run To F
ile
D
emo Dispense Mode
15. Heater - Activates Heater Control for Windows.
16. Manual Board Load
- An operator-conducted function for loading a board by hand. Place the
board at the mouth of the Conveyor. Use the dispensing system Conveyor Controls to set the
proper width. Manual Board Load conveys the board into the dispensing area and clamps it
into place.
17. Manual Board Unload
- Unclamps the board and conveys it to the end of the Conveyor for
manual unloading.
18. Download Conveyor Atom
- Downloads a specific set of instructions for controlling the Conveyor.
Run Menu
1. Go - Executes the current program. If Dry Mode is not
active, fluid will be dispensed. When the run is finished, a
dialog box opens indicating how much time the run took
to complete.
2. Dry Run
- A simulated run that checks XY positions only for
the current program. The Dispensing Head is not lowered to
the substrate and no fluid is dispensed. The Camera acts like
the needle, tracing the pattern so you can check locations.
3. Wet Run
- Executes the current program, dispensing fluid
during the run.
4. Pass Through Run
– No dispensing is performed. The part is conveyed through the system as if it
were in production mode.
5. Stop
– Stops a production run. The current board is dispensed before the system stops.
6. Pause
- Pauses a production run. The current board is dispensed before the system pauses.
7. Single Step
- Executes the current program one step at a time, stopping after each step to allow you
to check accuracy and to edit the program if necessary.
8. Abort
- Stops a run completely after executing the last command it received before receiving the
Abort command.
9. Run From Cursor
- Allows you to place the cursor anywhere within a dispensing program and
execute only the commands below the cursor location. The Run From Cursor feature works best if
used in the Main Program or Workpiece Pattern. Complex programs may not work correctly if the
cursor is placed inside repeated patterns, loop instructions, or conditional statement blocks.
10. Manual Board Load
- Allows you to manually convey a board or part into the dispensing system.
11. Manual Board Unload
- Allows you to manually convey a board or part out of the
dispensing system.