Manual

Tools 9-5
Figure 9-3 Heater Control Window
4. Click on On/Off to turn the channels on and off. Click on Help in any of the dialog boxes
for detailed explanations of all features and options. Click on
Exit to close the Heater
Control Window.
" NOTE Not every available Heater loop will be connected to a functioning heater
element. The loop names are set at the Asymtek factory, but can be changed to
fit your specific requirements.
Loop Parameters
To display detailed information about a specific Heater loop, double click the loop name. The Loop
Parameters dialog box shown in Figure 9-4 opens. The Loop Parameters dialog box contains six tabs
described below. Click on the tab to view its options.
To close the Loop Parameters dialog box and save changes, click
OK. To close the Loop Parameters
dialog box without saving changes, click
Cancel. The Loop Parameters dialog box will close and you
will return to the Heater Control Window.