Manual

Tools 9-3
Terminal
Click on Terminal to display a drop-down menu allowing direct communication with the Dispenser, the
Conveyor, the Scale, and the Heater. See Figure 9-2.
Dispenser
Opens a Terminal Mode window in which you can
communicate directly with the Dispenser by using
PMAC (for M-2000 and X-1000 dispensing systems) or
ACL commands (for all other systems).
Conveyor
Opens a Terminal Mode window in which you can
communicate directly with the Conveyor by using
Automove Control Language (ACL) commands.
Systems equipped with dual Conveyors will have two
Conveyor buttons, one for each Conveyor.
Scale
Opens a Terminal Mode window in which you can
communicate directly with the Scale. The Scale uses its
own command language. The commands are only valid
for the DI Series Scale.
Heater
If your system is equipped with heaters, the Heater
button accesses the Heater Controls. Refer to “Heater
Control Window” in this section for detailed instructions.
MPC555
Controller
Opens a dialog box in which you can communicate with
the MPC555 controller. This button will only be visible
on systems equipped with the MPC555 controller
(X-1000 Series).
Figure 9-2 Tools Window – Terminal