Manual

2-4 Installation
FmNT File Structure
During a typical installation, the Fluidmove for Windows NT program files are stored in the FmNT folder
on your computer hard drive. Your particular dispensing system may be setup differently.
CAUTION! Do NOT modify or delete any files in the FmNT folder or your dispensing system
may not operate properly.
FMCONFIG.INI FILE
During the installation process, the FMCONFIG.INI file is created. This file contains settings for your
system hardware. This file is typically stored in the FmNT folder.
CAUTION! Do NOT modify or delete the FMCONFIG.INI file. An error is this file can cause
your system to run erratically or not at all. Contact your Systems Engineer or
Asymtek Technical Support for assistance.
Standard Filename Conventions
During the setup, configuration, and programming process, FmNT creates certain files to store
configuration and programming information. Table 2-1 lists standard file extensions, file types, and
descriptions.
Table 2-1 Standard Filename Conventions
File
Extension
File Type Description
.avw Vision File
Vision files store fiducial and light-level
information.
.flu Fluid File
Fluid files store specific information about fluid
dispensing parameters and the Fluid Manager.
.fmw
Fluidmove
Program File
Program files contain dispensing instructions
and procedures.
.htr
.htc
(X-1000)
Heater File
Heater files store information about heater
configuration.
.ini
Configuration
File
Configuration files contain configuration
information specific to your dispensing system.
.log Log file Log files contain production statistics.
.pss
Setup Script
files
Script files contain setup information such as
valve type.
.rcp Recipe
A recipe file is a combination of a program file,
vision file, fluid file, and heater file.