Manual

7-48 Advanced Programming

To program dots using Dynamic Dispense Control:

" NOTE When programming dots, additional DDC settings are available through the Edit

Dot Parameters menu option.

1. Click

Teach a Program from the Main Window.

2. In the Programming Window, click on

Edit and select Edit Dot Parameters.

3. Click on the

Encoder-controlled Dots tab.

! The screen shown in Figure 7-31 opens.

Figure 7-31 Encoder Controlled Dots

4. Make sure there is a checkmark in the Pos Ctrl On checkbox next to appropriate dot type. If

not, click on the box to turn this feature on.

5. Set the desired speed and acceleration.

! The percentage value is the percentage of the maximum motor speed. Higher values

result in faster motor speed. Lower values result in slower motor speed.

Valve On is entered in counts rather than in time. There are 38,000 counts per revolution.