Manual

Advanced Programming 7-41
Exercise 7-4: Variable Valve Speed
1. Perform the Programming Setup procedure described in the Programming Basics and
Setup section.
2. Click on
Teach a Program to open the Programming Window.
3. Click on the
Dispensing Elements button on the Program Commands toolbar.
4. Click on
Weight Control Lines on the Dispensing Elements toolbar.
5. In the Total Weight text box, type
10.
! Entering 10 mg means that 10 mg of fluid will be dispensed along the length of the line
you will now define.
6. Move the camera crosshairs to the beginning of the bottom Basic Line on Side 1 of the
Tutorial Board.
7. Click on
Teach.
8. Move the camera crosshairs to the end of the line.
9. Click on
Teach.
10. Click on
Done.
! A message box opens listing the calculated line speeds for the valve speeds previously
defined in the Mass Flow Calibration Table. See Figure 7-22.
20%
30%
50%
0.983
2.917
5.300
Figure 7-22 Calculated Line Speeds