Manual

7-24 Advanced Programming
111. Watch to make sure that the program, performs the following steps:
! Finds two corner fiducials on the workpiece.
! Finds the Workpiece skip mark.
! Finds the fiducials at each flip chip model location for the
Lfill pattern.
! Finds the
Lfill skip marks.
"NOTE The skip mark for the second flip chip model should not be found and the pattern
should be skipped.
! Performs a Flow Rate measurement.
" NOTE The Flow Rate measurement will be performed on Wet Runs only.
! Performs a Substrate Height Measurement.
! Dry dispenses L-shaped lines around each of the flip chip models.
! Waits for the timer to expire, then dry dispenses L-shaped lines around the opposite
corners of the flip chip models.