Manual

6-38 Beginning Programming
10. Click on Teach.
11. Test the fiducial by clicking on
Find Fid.
!The Test Results indicate if the fiducial was found or not, its found coordinates, how
certain the system is that it has found the correct fiducial, and how long it took to locate
the fiducial.
12. Click on
Done.
Editing a Program
After your dispensing program has been created you may edit it at any time. You may add, delete or edit
lines as necessary. In addition, you may edit dot and line location and dot and line parameters.
Opening a Program and Pattern
To open a program and pattern:
1. Load the workpiece.
2. Select
Teach a Program from the Main Menu.
!The Workpiece pattern of the last saved program opens.
!To select a different program, choose
File>Open from the menu bar and select the desired
program from the list.
3. Make sure that the name of the pattern containing the fiducials you wish to edit appears in the
Pattern Name text box.
!If it doesn’t, click on the arrow next to the Pattern Name text box and select the pattern
from the drop-down menu.
!Refer to the Advanced Programming section of this manual for information on patterns.
Adding Program Commands
To add program commands:
1. Perform the steps outlined in “Opening a Program and Pattern” above.
2. Move the cursor to the line where you would like your new command to appear.
!The new command will be inserted above the cursor position.
3. Select the desired command on the
Program Commands toolbar.
!Follow the instructions on the screen.
!The new line will be inserted into your program and the lines will be renumbered.