Manual

Beginning Programming 6-33
31. Click on Apply.
32. Click on
OK.
33. Click on
File>Save on the menu bar or click on the Save button and enter Lines
for the filename.
!Your program should appear similar to the one below.
Lines
Workpiece
WEIGHT CONTROL:20,1,…
2 WEIGHT CONTROL:25,1,…
3 WEIGHT CONTROL:35,1,…
4END:
1
Lines
Workpiece
Lines
Workpiece
WEIGHT CONTROL:20,1,…
2 WEIGHT CONTROL:25,1,…
3 WEIGHT CONTROL:35,1,…
4END:
1 WEIGHT CONTROL:20,1,…
2 WEIGHT CONTROL:25,1,…
3 WEIGHT CONTROL:35,1,…
4END:
1
Figure 6-14 Lines Program – Workpiece Pattern
34. In the Programming Window, select Run>Dry Run from the menu bar.
!The Dispensing Head will move after your response.
35. Watch to see the camera traverse the programmed lines. You may observe a difference in
dispensing speed for each line.
!If you get an error message that the speed is too slow, re-check your line parameters and
try again. Refer to “Editing Fiducials” later in this section.
36. In the Programming Window, select
Run>Wet Run from the menu bar.
!Watch as the lines are dispensed.
!Examine the board for quality and accuracy.