Manual

6-32 Beginning Programming
15. Repeat Steps 6 through 8 and type in 25 mg for the next line.
16. Move the camera crosshairs to the beginning of the next line on the Tutorial Board.
17. Click on
Teach.
18. Move the camera crosshairs to the end of the line.
19. Click on
Teach.
20. Click on
Done.
!A message box opens, indicating the calculated line speed for the newly created weight
control line.
21. Click on
OK.
22. Repeat Steps 6 through 8 and type in
35 mg for the next line.
23. Move camera crosshairs to the beginning of the last line on the Tutorial Board.
24. Click on Teach.
25. Move the camera crosshairs to the end of the line.
26. Click on
Teach.
27. Click on
Done.
!A message box opens, indicating the calculated line speed for the newly created weight
control line.
28. Click on
OK.
29. In the Programming Window, select
Edit>Edit Line Parameters from menu bar to open the
Line Parameters dialog box.
30. Set the Line Parameters for Line Type 1 to:
Pre-Move Delay Factor: 0.1
Down Speed: 2
Down Acceleration: 300
Dispense Gap: 0.015
Speed: (not used for weight control lines)
Shut-off Distance: 0.010
Suckback: 0.000
Dwell: 0.0
Backtrack Gap: 0.050
Backtrack Length: 0.040
Backtrack Speed: 2
Retract Distance: 0.100
Retract Speed: 2
Retract Acceleration: 300