Manual

6-2 Beginning Programming
Creating a Program
1. Select Teach a Program from the Main Menu.
!The Programming Window opens. The last saved program will appear in the
Programming Window.
2. To create a new program, select
File>New from the menu bar or click on the Program Wizard
icon on the toolbar.
!The Programming Window shown in Figure 6-1 opens. Notice that, by default, the
Workpiece pattern opens.
Figure 6-1 Programming Window
" NOTE All FmNT programs contain a Workpiece pattern. The Workpiece pattern may
contain dispensing commands as well as commands to execute additional
patterns. Refer to the Advanced Programming section of this manual for
instructions on creating a pattern.
3. You are now ready to enter program commands.
!Notice that the Pattern End instruction is included in the program.
4. To enter a new program command, position your cursor at the beginning of “Line 1” and press
enter to insert a blank line.
5. Select the desired program command from the Program Commands Toolbar at the right of the
Programming Window and follow the prompts. See “Dispensing Commands” in this section.
Pattern Name
Program Name
Pattern End
Instruction
Fluid File