Manual

5-30 Programming Basics and Setup
Attaching a Fluid File
1. Click
File>Fluid Table from the Programming Window menu bar.
!A drop-down menu with options for loading previously saved fluid files opens.
2. Select the desired fluid file.
3. Click
OK.
Loading a Board
1. For systems equipped with a Conveyor, set the Tutorial Board (Side 1) at the mouth of
the Conveyor.
!Use the dispensing system Conveyor Controls or the Jog Commands in FmNT to set the
proper width.
!Click on the
Load Board icon to load the board into the dispensing area. The clamps
should push the board up to the bottom of the rail slot.
2. For gantry dispensing systems, place the Tutorial Board (Side 1) onto the heat plate or
dispensing area plate and fasten with the tooling pins.
Creating a New Program File
1. In the Programming Window, click on
File and select New or click on Program Wizard
to create a new program.
!The Create Workpiece dialog box opens. See Figure 5-16.
Figure 5-16 Create Workpiece