Manual

5-18 Programming Basics and Setup
8. Click on the Attach Script Files tab (if present). This tab will not appear if you are not using
script files for program setup.
!Select the desired Script File categories by clicking the check box to the left of the
"Prompted Setup," "Change Syringe," and/or "Low Fluid" button. Categories not selected
will use the script files specified in "Setup Script Options" on the Configuration menu.
!Click on the desired category button and select the appropriate script file from the list. The
file name will appear in the text box under the button.
" NOTE If the same fluid file is being used for both Valve 1 and Valve 2, the script files
will be the same for both valves.
9. Click on one of the following buttons at the bottom of the dialog box to exit and return to the
Main Window:
!
OK allows usage of the settings, but will not save the settings to the fluid file.
!
Save saves the settings to the fluid file.
!
Cancel closes the dialog box and does not retain any of the new/changed settings.
Workpiece Alignment
Workpiece alignment refers to the position of the board or part in relation to the Dispensing Head X- and
Y-axes. Even if the board is slightly askew, FmNT can use workpiece alignment to adjust the patterns
and dispense correctly. Once you have established workpiece alignment parameters, workpiece
alignment will be performed at the beginning of each production run and at the beginning of each new
board in the run. Checking for workpiece alignment can be eliminated if speed is a factor. In that case,
correct workpiece alignment and symmetry are assumed.
To setup workpiece alignment:
1. Select
Setup Workpiece Alignment from the Configuration menu and make sure there is a
checkmark in the box next to “Learn Workpiece Angle first.” See Figure 5-10.
!If you select “Learn Workpiece Angle first,” you will be prompted to define the workpiece
orientation in the X- or Y-axis when you begin programming.
!FmNT compares the defined axis to the Dispensing Head axis to adjust for workpiece
alignment.
" NOTE If Setup Workpiece Alignment is not activated, you will be asked if you want to
“Learn Workpiece Angle first?” each time you begin a new programming
session. However, to ensure workpiece alignment, it is a good idea to activate
this feature in the Configuration menu.