Manual

4-76 System Configuration and Setup
Figure 4-31 Prompted Setup Teach Window
7. Make sure the work area is clear of any obstacles so the Dispensing Head does not collide
with anything when it moves.
8. Click on
Next.
9. You will be prompted to check the purge and scale cup.
10. Click
Next when done.
11. You will then be prompted to change the purge boot, if necessary.
12. Change if necessary and click
Next when done.
13. You will then be prompted to install a new needle, shield, etc.
14. Install if necessary and click
Next when done.
!In this example Valve Offsets is the selected initial setup procedure. Refer to “Machine
Offsets” in the System Configuration and Setup section for instructions on selecting an
initial setup procedure.