Manual

4-70 System Configuration and Setup
47. Click on Teach.
!The Dispensing Head performs a height sense in the defined location, and then lowers the
needle tip into the Scale Station opening.
48. Click on
Done.
!A new Teach Window opens asking you to place a sample substrate on top of the Needle
Sensor and select a dot style.
49. If a sample substrate is not already in place on top of the Needle Sensor, place one there now.
50. Select a dot style.
!You can create different dot styles by assigning specific values to configurable dot
parameters. Click on
Edit to view all dot parameters.
51. Click on
Enable Verification Step to activate the feature, if desired.
52. Click on
Next.
!A message box opens asking if you want to "reteach substrate corners."
53. Click on
Yes.
54. Use the Position Controls to center the Camera crosshairs on the upper left-hand corner of the
sample substrate.
55. Click on
Teach.
56. Use the Position Controls to center the Camera crosshairs on the lower right-hand corner of
the sample substrate.
57. Click on
Teach.
!The Dispensing Head moves to the Purge Station and performs a purge, then moves to the
Needle Sensor and dispenses four dots on the sample substrate.
58. Use the Position Controls to align the Camera crosshairs with the first dot, if necessary.
59. Click on
Teach.
60. Repeat the two previous steps for the other three dots.
!If you are using the Verification Step, you will be asked twice to align the Camera
crosshairs to the dots.
61. Click on
Done when complete.
62. Click on
OK.
63. Click on
Exit.