Manual

System Configuration and Setup 4-67
10. Click on Run to End.
!A message box opens indicating "This script file performs Camera Assisted Valve Offsets."
11. Click on
OK.
!A Teach Window opens asking you to teach a safe Z height.
!Toggle Probe raises and lowers the Height Sensor probe.
!The Value text box indicates the previous safe Z height, if one has been established.
Clicking on
GoTo will move the Dispensing Head to that height.
12. Use the Position Controls to raise or lower the Dispensing Head until a safe Z height
is achieved.
13. Click on
Teach.
14. Click on
Done.
!A new Teach Window opens asking you to align the needle to a mark on the sample
substrate on top of the Needle Sensor.
!If there is no mark on the sample substrate, use a pen or pencil to make one anywhere on
the sample substrate. An "X" works best.
15. Use the Position Controls to align the needle tip to the center of the mark on the
sample substrate.
16. Click on
Teach.
17. Use the Position Controls to align the Camera crosshairs to the center of the same mark.
18. Click on
Teach.
19. Click on
Done.
!A new Teach Window opens asking you to align the Height Sensor probe to a mark on the
sample substrate. You can use the same mark used in the previous steps.
20. Use the Position Controls to align the tip of the Height Sensor probe to the center of the mark
on the sample substrate.
21. Click on Teach.
22. Use the Position Controls to align the Camera crosshairs to the center of the same mark.
23. Click on Teach.
24. Click on
Done.
!A new Teach Window opens asking you to select a method for teaching the center of the
Tactile Sensor on top of the Needle Sensor.
The Tactile Sensor is for automatic height senses.