Manual

System Configuration and Setup 4-51
Table 4-12 Setup Dispenser Options
Command Description
Dispenser
Type - Identifies the type of Dispenser Controller on your system.
Scale - Refers to the smallest increment of movement capable by the
Dispensing Head.
Firmware Rev. - Identifies the firmware and revision level installed on
your dispensing system.
Run Recovery
Enable Run Recovery - Enables the Run Recovery feature, which
continues dispensing after a program has been aborted from the point
at which it was aborted.
Recovery Prompt Position - This number determines when the "Start
dispensing at the next instruction?" question is asked when recovering
a failed board.
Skip Dry Run Recovery - If active, the Dispensing Head will move
directly to the last position before the run was aborted and begin
dispensing.
Accuracy Mode
Fast - Highest throughput. Best for programs with minimum number
of fiducials and/or skip marks. (Available on M-2000 Series
Dispensing Systems only.)
Standard - Normal setting for Dispensing Head movement.
Precision – Highest accuracy. Best for programs with a high number
of fiducials and/or skip marks, and where accuracy is more important
than throughput.
Correction Table
FmNT - The FmNT correction table will be used to ensure Dispensing
Head location.
Controller -The correction table downloaded into the Dispenser
Controller (included on the calibration diskette located on the inside of
the lower front door) will be used to ensure Dispensing Head location.
Data File Name -The name of the correction table file included on the
calibration diskette. This file is specific to your particular dispensing
system.
Dispenser Files
Startup File Name - Executes the chosen dispenser file at FmNT
startup.
Pre-Board Run File Name - Executes the chosen dispenser file before
dispensing begins.
At Reset File Name - Executes the chosen dispenser file after resetting
the dispenser.
At Abort File Name - Executes the chosen dispenser file when a
program has been aborted.
Change - Choose the dispenser control file you want to execute during
the selected system condition.
Reinitialization - Downloads the calibration file for the Dispenser
Controller.