Instruction Manual

6-32 Setup and Configuration
14. Place the Tutorial Board as follows, depending on the type of dispensing system you have:
A. For systems equipped with a conveyor, set the Tutorial Board (Side 1) at the mouth of
the conveyor. Use the dispensing system Conveyor Controls or the Jog Commands in
FmNT to set the proper width. Click on the Load Board icon.
> The board is loaded into the dispensing area. The clamps should push the board up to
the bottom of the rail slot.
B. For gantry dispensing systems, place the Tutorial Board (Side 1) onto the heat plate or
dispensing area plate and fasten with the tooling pins.
15. In the Programming Window, click on Program Wizard
to create a new program.
> The Create Workpiece dialog box opens.
16. Choose
Two fiducials.
17. Click on
OK.
> A Teach Window opens asking you to teach the first point defining axis. This will define
the Workpiece Alignment.
18. Use the Position Controls to move the dispensing head to the start of one of the Basic Lines
near the top of the Tutorial Board.
> Center the crosshairs on the line.
19. Click on
Teach.
20. Use the Position Controls to move the dispensing head to the end of the same line.
> Center the crosshairs on the line.
21. Click on
Teach.
> You have just defined the Workpiece Alignment.
> The Teach Window changes, asking you to teach the Workpiece origin.
22. Use the Position Controls to move the dispensing head to the dot in the upper left-hand
corner (ULHC) of the Tutorial Board.
> Center the crosshairs on the dot.
23. Click on
Teach.
24. Click on
Done.
> The Teach Window changes again and you are asked to select a method for teaching the
first fiducial.
?NOTE You may want to review the “Fiducial Detection” information in the
Programming Basics section of this manual before continuing this exercise, but it
is not required.
25. Select
Model Finder.