Instruction Manual

Setup and Configuration 6-31
Dispensing System
Home Position
Origin of
Workpiece (0,0)
Workpiece Angle
Workpiece
Workpiece
x-axis
x-axis
Dispensing
System
y-axis
Dispensing
System
Defined pojnts along
Workpiece x-axis
Workpiece
y-axis
Figure 6-16
5. Click on Configuration.
6. From the Configuration menu, select
Setup Fluid Manager to open the Fluid Manager
dialog box, shown in Figure 6-15.
7. On the
Purge Parameters tab, disable the Purge Maintenance feature by clicking on the box
next to
Enable Purge Maintenance. The box should be blank when Purge Maintenance is
disabled.
> It is recommended that you disable Purge Maintenance for the tutorial exercises. This
means that the system will not automatically purge while in a production run mode and
will not purge during programming. Or, set the option for over 900 seconds so that your
programming runs are not interrupted by automatic purging while running test programs.
8. Click on the
Pot Life/Low Fluid Check tab and enter the information on the fluid you will be
using for this tutorial (Hysol 4510 or equivalent).
> The Pot Life should be documented in the material information data sheet.
9. Click on
Save.
> FmNT takes you back to the Main Window.
10. Click on
Teach a Program.
11. Select
File from the Programming Window menu bar.
12. Select
Fluid Table, and then Save As.
> Save the Fluid File as a
<filename>.flu file. You will attach this file to your program
later.
13. Click on
OK.