Instruction Manual

6-10 Setup and Configuration
34. Select Setup Heaters from the Configuration menu.
> The Heater dialog box opens. See Figure 6-8.
Figure 6-8
35. Click on the arrow next to the Heater (1 or 2) box and select the type of heater controller
installed on your dispensing system.
> Heater 1 refers to the left-most heater station. Heater 2 refers to the right-most heater
station. Each heater station needs to be active in order for you to be able to configure it,
and each heater station needs to be configured individually.
> Generally, the type of heater controller installed on your dispensing system is Anafaze.
MPC555 is the heater controller on all X-1000 Series Dispensing Systems. If your
dispensing system is not equipped with heaters, select
(none).
> Consult the Online Help for explanations of all features in this dialog box.
?NOTE Configuring the heaters is not the same as setting up the heaters. Refer to the
Heater Controls section of this manual for heater setup instructions.
36. Click on
OK.
?NOTE System Configuration is now complete and FmNT must be restarted for all of the
changes to take effect. Refer to the Tour of Fluidmove section of this manual for
startup instructions.
37. In the Main Window, click on
Exit.
This concludes the System Configuration procedure.