Instruction Manual

Heater Controls 4-3
Each loop has a dialog box which shows its settings under the Main tab.
Figure 4-2 shows the Loop Parameters dialog box. On the Main tab, you set the temperature with
Set Point (SP). The Output Value is the percentage of the total capacity of the heater being used
to achieve or maintain the
Set Point. Auto Mode regulates the loop temperature automatically.
Manual Mode disables the automatic temperature controller and allows you to regulate loop
temperature using the
Output Value.
?NOTE Operating in Manual Mode is not recommended. Output Value can not exceed
Heat Output Limit. See the Output tab.
Figure 4-2
Select the Run Time tab.