Instruction Manual

3-20 Tour of Fluidmove
You can use the X-Y-Z Position Controls in the Teach Window, as shown in Figure 3-15, using a mouse
or trackball. Or you can use the mouse or trackball to point and click on a location within the video
display, or within the Target Box, to move the dispensing head around the dispensing area.
To get used to using the Position Controls in FmNT, click on the and then .
WARNING! The dispensing head will move approximately 50 mils to the right.
Now, click on a location in the Target Box. The crosshairs and the dispensing head move to the new
location.
WARNING! The dispensing head will move to the new location.
To exit the Teach Window, click Cancel.
To exit the Programming Window and return to the Main Window, click on the Process Toolbar.
In the Main Window, click on Run a Program.