Instruction Manual

Tour of Fluidmove 3-15
Process Toolbar
The commands associated with each icon on the Process Toolbar are identified below. However, you will
notice that FmNT toolbars have Tool Tips. As you move the cursor over a button, a “tip” appears below
the button, explaining its function. If a button is greyed-out, that means that the command is not available
at this point in the programming session. The Wet/Dry Run Mode and Video Display buttons toggle to
change between the two modes.
Item Description
1 Create a New Program
2 Open a Program File
3 Save Current Program
4 Print Current Program
5 Cut Program Line
6 Copy Program Line
7 Paste Program Line
8 Run Current Program
9 Pause Run After Next Command
10 Stop Run at End of Current Board
11 Run Program in Steps
12 Abort Run
13 Load a Board
14 Unload a Board
15 Toggle Wet or Dry Run Mode
16 Move Dispensing Head to Home Position
17 Toggle Video Display On or Off
18 Purge Valve
19 Measure Flow Rate
20 Access Jog Controls
21 Access Online Help
22 Return to Main Window
Figure 3-11
4
3
5
6
7
8 9
10
11
12
13
14
15
16
17
18
19
20
21
22
2
1