Instruction Manual

Tour of Fluidmove 3-9
Figure 3-5
Clicking on Dispenser, Conveyor 1 or Scale will bring up a Terminal Mode window. You can
communicate directly with the selected device by typing commands in the Terminal Mode Window.
Clicking on
Heater opens the Heater Controls for configuring heater operation. For information on
device commands, contact Asymtek Application Engineering.
?NOTE Dispensing systems equipped with dual-lane conveyors will have two conveyor
buttons in this window, one for each conveyor. Two heater buttons may also be
visible in this window, depending on system configuration. The heaters are
discussed in more detail in the Heater Controls section of this manual.
?NOTE X-1000 Series dispensing systems will also have an additional button for
communicating with the
MPC555 controller.
Click on Dispenser to see an example of the Terminal Mode window.
Click on Exit to close the Terminal Mode Window and return to the Tools Window.
Click on I/O Test in the Tools Window.