Instruction Manual

Tour of Fluidmove 3-3
User Interface
You will find that the FmNT user interface was designed to utilize the simplicity and intuitiveness of
Windows-based software. In this section, you will learn how to start FmNT and you will visit all of the
major windows and menus within the FmNT environment.
Starting FmNT
The FmNT start-up procedure assumes that FmNT is already installed on your computer, and that the
computer is turned ON and running Windows NT.
?NOTE If your computer is not running Windows NT, consult your Information Service
Group.
To start FmNT:
1. Click on
Start in the lower left-hand corner of your computer screen.
2. Select
Programs from the Start menu.
3. Select
FMNT from the Programs menu.
4. Click on
to start FmNT.
> FmNT will now start. It will check to see that all the Input and Output (I/O) devices for
your dispensing system are communicating properly with FmNT.
CAUTION! Do not press any keys or the mouse while FmNT is booting.
Help If you get any errors regarding the Conveyor, Dispenser, Heaters or Vision
System, refer back to the Getting Started section of this manual and check the
readiness of your dispensing system.