Instruction Manual

Index - 1
Index
–A–
alarms, 4-8
Anafaze, 4-1
area fill, 8-21
Asymtek Vision for Windows (AVW), 3-2
automatic back-ups, 2-3
–B–
backtrack gap, 8-6
backtrack length, 8-7
–C–
calibration, 3-1
camera, 6-16
caliper tool, 7-11
calipers
density, 7-13
sizing, 7-13
camera
calibration, 6-15
on/off, 3-15
video overlay, 3-2, 3-18
camera-offset, 3-1
chip offset, 6-17, 9-2
chip tolerance, 3-1
commands, 3-13, 3-15, 3-16, 3-17, 7-1
configuration, 3-4, 6-1, 6-15
configuration menu, 3-6
conveyor, 6-1
conveyor controls, 3-11
cooling devices, 4-1
corner finder, 7-5, 7-11
corner finding, 3-1
–D–
defaults, 8-10, 8-14
dispense gap, 8-6, 8-12
dispensing
area fill, 8-21
commands, 3-17
control, 8-6, 8-12
speed, 8-6
wet/dry, 3-15
dispensing elements toolbar, 3-17
dispensing head controls, 3-11, 3-18, 3-20
dispensing program, 3-12
loading, 3-22
dispensing system
setup, 3-1
dots
parameters, 8-11
down acceleration, 8-11
down speed, 8-6, 8-11
dwell, 8-6, 8-12
–E–
edge detection, 7-5, 7-11
encapsulation, 8-21
event log, 6-11, 6-13
–F–
fiducials, 6-30, 7-5
accept threshold, 7-9
confusion threshold, 7-9
corner finder, 7-13
corner finding, 3-1, 7-11
editing, 7-15
model fiducials, 7-5, 7-8
quality, 7-5, 7-6, 7-11
recognition, 3-1, 7-5, 7-11
re-use, 9-1, 9-5
samples, 7-7
single fiducial, 7-11, 7-12
skipping, 9-1
teaching, 7-8
filenames, 3-22, 6-13, 6-28
flow rate
calibration data, 3-2
fluid cooling devices, 4-1
fluids, 8-6
fluid files, 6-28, 6-31
fluid lot data, 3-2, 3-25, 6-28
fluid setup, 3-6, 3-22
FmNT
starting, 3-3
–G–
gantry, 6-32
–H–
Heater Control. See also Heaters
heater files, 3-22
heaters
controller, 4-2
heater control, 4-1
heater setup, 4-1
input offset, 4-6
loop names, 4-2, 4-3
manual mode, 4-3
needle heater, 4-1
output value, 4-3
set point, 4-3
temperature deviations, 4-8
thermocouple type, 4-6
time proportioning alarms, 4-8
height sensor, 3-2, 6-1, 6-19, 6-20, 6-21, 6-22, 9-5