Instruction Manual

10-2 Running Production
8. After the file has loaded, click on Run in the Production Window.
9. Click on
Run Production.
> The Run Window opens. See Figure 10-1.
> A message box appears requesting you to “Clear the conveyor”.
10. Clear the conveyor.
> Click on
Jog to access the conveyor controls, if necessary.
11. Click on
OK.
12. Place a Tutorial Board at the mouth of the conveyor.
13. Click on
Go.
> The message “Waiting for a board” will appear.
> The Tutorial Board will be conveyed into the dispensing area. Stop pins will activate to
stop the board at the Dispense Zone. Lifter tables or bar clamps will clamp the part in
place. Dispensing will be performed.
Figure 10-1