Instruction Manual

9-20 Advanced Programming
88. From the File menu, select Save.
89. From the
Run menu, select Dry Run.
> Make certain that the program executes the following steps correctly:
• Finds two corner fiducials on the workpiece.
• Finds the fiducials at each flip chip model location for the
U-pass pattern.
• Perform a Flow Rate measurement. (Only performed on Wet Run.)
• Performs a substrate height measurement.
• Dry dispenses two lines around each of the flip chip models.
• Waits for the timer to expire, then dry dispenses a single U-shaped line around each
of the flip chip models.
90. When you are satisfied that the program executes correctly, select
Wet Run from the Run
menu.
This concludes the tutorial on a U-shaped Multipass Workpiece.