Instruction Manual

9-16 Advanced Programming
28. Click on Teach.
> The program should look like this:
1 START PASS: FOR PASS 1
2 FIND SUBSTRATE HEIGHT: (x, y)
3 END PASS:
4 START PASS: FOR PASS 2
5 END PASS:
6 START PASS: FOR PASS 3
7 END PASS:
6END
29. From the Program Commands toolbar, click on Dispensing Elements.
30. Click on
Weight Control Lines.
31. Enter
30 mg in the Total Weight text box and select Line Style 1.
32. Use the Position Controls to move the dispensing head to the ULHC of the first flip chip
model in the second row of flip chip models.
> Use Chip Offset or reticles.
33. Click on
Teach.
34. Use the Position Controls to move the dispensing head to the URHC of the same flip chip.
> Use Chip Offset or reticles.
35. Click on
Teach.
36. Click on
Done.
37. From the Program Commands toolbar, click on
Time.
38. Select
Reset Multipass Timer.
> This will start a new timer for the second underfill line.
39. Place the cursor on the second
END PASS and click on Time in the Program Commands
toolbar.
40. Select
Await Multipass Timer.
41. Type in
20 seconds and click on OK.
42. Place the cursor on
END PASS (for Pass 2).
43. From the Program Commands toolbar, click on
Dispensing Elements.
44. Click on
Weight Control Lines.