Instruction Manual

Tour of Fluidmove 3-1
3 Tour of Fluidmove
Overview
This chapter provides a tour of the unique Windows Graphic User Interface (GUI) of FmNT. Each
window will be visited and explained in detail, along with all icons, toolbars and message areas. After
reading this chapter, you will be ready to start the programming exercises.
Estimated time to complete: 20 minutes
System Setup and Operation
To use FmNT, it is necessary to make sure that your dispensing system is in a known ready state. Refer
to the Operations Manual for your dispensing system for Startup and Setup information that may be
specific to your particular system.
Features
FmNT is designed to simplify programming and testing of complex dispensing routines that require
explicit machine and fluid controls. In addition, FmNT can be used by a variety of users, from process
engineers to production operators. Menu access is restricted by passwords, while providing the user the
flexibility needed to complete the job efficiently.
Some of the features which make FmNT a flexible and easy-to-use benchmark for dispensing system
software are briefly described below.
Advanced Vision System Support
Asymtek dispensing systems using FmNT are equipped with an advanced camera/light vision system
called Asymtek Vision for Windows (AVW). This system is an integrated application within FmNT. It
allows you to see the board onto which you are dispensing by providing a video overlay of the board in a
fully integrated
FmNT window. It also allows for control of light levels, camera-offset, corner finding
algorithms, fiducial recognition, skew correction, chip tolerance, and part skipping, allowing you to
optimize them as necessary to perfect your dispensing process.
Simplified Setup/Configuration Routines
Dispensing systems are complex and must be calibrated with the process you are performing. In addition,
process programmers require a different setup procedure than a production operator.
The FmNT Main Window allows you to access and setup programming options and preferences such as
measurement, workpiece alignment, fluid setup, and access levels. Also, from the Configuration menu, a
Master Offsets routine prompts you through initial system and software calibration for the Height Sensor,
Camera Offset, Purge Station and Weigh Station locations, making initial setup fast and easy. The
Production Window also has a Setup menu designed for use by production operators. Manual setup
options are also available for specific setup tasks, giving the operator quick control over all production
functions.