Instruction Manual

Advanced Programming 9-13
112. From the Run menu, select Wet Run.
> Watch to make sure that the program, performs the following:
• Finds two corner fiducials on the workpiece.
• Finds the Workpiece skip mark.
• Finds the fiducials at each flip chip model location for the
Lfill pattern.
• Finds the
Lfill skip marks.
?NOTE The skip mark for the second flip chip model should not be found and the pattern
should be skipped.
• Performs a Flow Rate measurement. (Only performed on Wet Run.)
• Performs a Substrate Height Measurement.
• Dry dispenses L-shaped lines around each of the flip chip models.
• Waits for the timer to expire, then dry dispenses L-shaped lines around the opposite
corners of the flip chip models.
This concludes the tutorial on an L-shaped Underfill Pattern.
In the next exercise, you will learn how to program a U-shaped multipass program as shown in
Figure 9-2. Skip marks will not be used.