Instruction Manual

9-10 Advanced Programming
64. From the File menu, select Save and type in undrfil.fmw to save your program as
undrfil.fmw.
> Your program should look like this:
1 START PASS: FOR PASS 1
2 FIND SUBSTRATE HEIGHT: (x, y)
3 WEIGHT CONTROL:50.00, 1, ([x
1
, y
1
],[x
2
, y
2
], [x
3
, y
3
])
4 RESET MULTIPASS TIMER:
5 END PASS:
6 START PASS: FOR PASS 2
7 AWAIT MULTIPASS TIMER: 10 seconds(s)
8 WEIGHT CONTROL:30.000,1, ([x
1
, y
1
],[x
2
, y
2
], [x
3
, y
3
])
9 END PASS:
10 END
65. In the Pattern Name text box, select Workpiece.
> A message box opens indicating that the dispensing head is about to move to the
“Workpiece” origin.
> The dispensing head will move after your response.
66. Click on OK.
67. Place the cursor on
END.
68. From the Program Commands toolbar, click on
Process.
69. Select
Measure Flow Rate.
> A
Measure Flow Rate command is added to the dispensing program just above END.
70. To set up for placing the pattern
Lfill, click on Pattern on the Program Commands toolbar.
71. Select
Loop Block.
72. Type
2 in the Number of Passes text box for the two L-shaped passes in Lfill.
73. Click on
OK.
74. In the programming screen, place the cursor on
NEXT LOOP.
75. Click on
Pattern on the Program Commands toolbar.
76. Select
Place Multipass Pattern.
77. In the Teach Window, select
Lfill in the Available Patterns text box.