Instruction Manual

Advanced Programming 9-9
46. Click on Done.
> A message box opens indicating the calculated line speed.
47. Click on
OK.
48. From the Program Commands toolbar, click on
Time and select Reset Multipass Timer.
> This will start the timer after the first line is dispensed.
49. Place the cursor on the second
END PASS and click on Time in the Program Commands
toolbar.
50. Select
Await Multipass Timer.
> The Await Multipass Timer instruction dialog box opens.
51. Type in
10 seconds.
> The system will wait for 10 seconds before beginning the next run.
> Set the timer according to how long your fluid takes to underfill the flip chip model.
52. Click on
OK.
53. From the Program Commands toolbar, click on
Dispensing Element.
54. Select
Weight-Control Lines.
55. Enter
30 mg in the Total Weight text box and select Line Style 1.
56. Use the Position Controls to move the dispensing head to the ULHC of the first flip chip
model in the top row of flip chip models.
> Use Chip Offset or reticles.
57. Click on
Teach.
58. Use the Position Controls to move the dispensing head to the LLHC of the same flip chip.
> Use Chip Offset or reticles.
59. Click on
Teach.
60. Use the Position Controls to move the dispensing head to the LRHC of the same flip chip.
> Use Chip Offset or reticles.
61. Click on
Teach.
62. Click on
Done.
> A message box opens indicating the calculated line speed.
63. Click on
OK.